Maintenance And Storage; Preparing To Operate The Lawnmower; Step 1 - Filling With Engine Oil - Qualcast XSS46B Assembly Manual

46cm petrol hand push lawnmower
Table of Contents

Advertisement

Safety Information
Important - Please read these instructions fully before operating or maintaining

Maintenance and Storage

a) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition;
b) Never store the equipment with petrol in the tank inside a building where fumes can reach an
open flame or spark;
c) Allow the engine to cool before storing in any enclosure;
d) To reduce the fire hazard, keep the engine, silencer, and petrol storage area free of grass,
leaves, or excessive grease;
e) Check the grass bag frequently for wear or deterioration;
f) Replace worn or damaged parts for safety;
g) If the fuel tank has to be drained, this should be done outdoors.
Customer Helpline 0845 034 2279
6
www.gardenservicecentre.co.uk

Preparing to Operate the Lawnmower

Step 1 - Filling with Engine Oil

CAUTION! The following procedures and adjustments must be performed before the engine is
started. Do not attempt to make any of these adjustments while the engine is running.
CAUTION! Always use high quality detergent oil classified SAE30 oil (or equivalent eg 5W 30,
Often termed as 4 Stroke lawn mower oil). Never use additives with recommended oil. To prolong
the life of your engine it is important that the oil is changed after the first 5 hours of use.
CAUTION! To prevent engine damage the engine is shipped without oil or petrol. The engine must
be filled with the correct grade of oil and petrol before starting the engine.
NOTE! Running the engine with a low oil level will cause engine damage. It is recommend that a
high detergent, premium quality 4-stroke engine oilis used. Using non-detergent oil can shorten
the engine's service life and using 2-stroke oil will damage the engine.
Check the engine oil level with the engine stopped and the mower on a level surface.
Remove the oil filler dipstick and wipe oil from it with a clean cloth.
Insert the dipstick into the oil filler neck, but do not screw it in.
Check the oil level. The oil level must be between the Min and Max marks on the dipstick. If near
the lower level, fill to upper level with the recommended oil (SAE30 or equivalent). Do not overfill.
Wipe away any spilt oil.
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
Add
Full
7

Advertisement

Table of Contents
loading

Table of Contents