Fujitsu PRIMERGY RX100 S6 Options Manual page 50

Installing an expansion card
A
Figure 31: Installing the riser module 2
Ê Insert the riser card into the system board slot (1).
Make sure that the two guiding bolts (A) of the riser holder engage correctly.
Ê If necessary, route the cables in the two cable clamps as before (2).
Ê If necessary, connect the cables to the expansion card and the other
components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
50
63.
Options Guide
RX100 S6