CDA FW971 Installation, Use And Maintenance Manual page 28

Adjusting the decor doors
The position of the decor doors can be adjusted on all 3 axis by
following the guide below. If the range of adjustment detailed below
is not enough then the refrigerator is likely not located correctly
in the cabinet and/or the upper decor fixing plates are incorrectly
positioned. We recommend another person holds the decor door
during these steps.
Horizontal Adjustment (Y):
1. Loosen the upper fixing plate nuts using a 10mm spanner ('Y' in Fig
21). These are on both sides of the fixing plate.
2. Slide the decor door and/or fixing plate left or right as required; this
gives approximately 5mm of adjustment.
3. Tighten the fixing nuts to lock the decor door in position.
Vertical Adjustment (X):
To adjust the vertical position of the door, use a 10mm to remove
the nut 'Y' in Fig. 22. Then, get the person helping you to lift the
decor door slightly to allow access for the spanner. Next, use a 14mm
spanner to turn the vertical adjustment nut marked 'X' in Fig. 23 to the
correct height.
Depth Adjustment (Z):
Ensure that the vertical and horizontal positions are correct before
adjusting the depth.
1. Loosen the depth adjustment screw (Z in Fig. 23).
28