Jogger Motor Replacement - Ricoh FT4460 Service Manual

9.4 JOGGER MOTOR REPLACEMENT

1. Remove the jogger unit wire tension spring [A]. (See the Jogger Unit Wire
Replacement section.)
2 . Disconnect the jogger motor connector [B] from the connector bracket.
3 . Remove the jogger motor assembly [C] (2 screws).
4. Separate the drive pulley [D] from the motor, and replace the motor.
5. Reassemble the unit and reposition the jogger fences.
NOTE: Make sure that the top of the jogger drive pulley is flush with the end
of the motor shaft.
5-115
28 February 1989