Bluetooth Connection - Bowers & Wilkins T7 Wireless Manual

Hide thumbs Also See for T7 Wireless:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
5. T7 Wireless audio inputs
T7 Wireless can play audio either wirelessly from
a compatible Bluetooth device or through a wired
connection from a device with an analogue output.
T7 Wireless will select between its Bluetooth and
wired inputs automatically although the Bluetooth
input has priority. The following input selection rules
apply:
• If T7 Wireless is connected via Bluetooth and
a plug is inserted in the Auxiliary input socket,
T7 Wireless will switch to the Auxiliary input.
• If T7 Wireless is playing audio through its
Auxiliary input and a Bluetooth stream is received
or the Bluetooth button is pressed, T7 Wireless
will switch to the Bluetooth input.
• If T7 Wireless is playing audio through its
Auxiliary input and the cable is disconnected
T7 Wireless will switch to the Bluetooth input
and attempt to connect to the primary paired
source device.
Note: If T7 Wireless is connected via Bluetooth
while an Auxiliary input cable is also connected, a
new analogue audio signal will not automatically
switch T7 Wireless to its Auxiliary input.

5.1 Bluetooth connection

To connect T7 Wireless to a Bluetooth enabled
audio device it must first be "paired" with the device.
Once paired, a Bluetooth device and T7 Wireless
will "remember" each other and be able to connect
when within range.
T7 Wireless will remember up to eight paired
Bluetooth devices. The first paired device will be
designated as the "primary" device, additional
devices will be designated as "secondary" devices.
The primary device will be connected when within
range, and the T7 Wireless Bluetooth button is
pressed.
Secondary devices will not connect automatically
when in range but must be connected via their
Bluetooth settings.
It is possible for two paired devices to be connected
to T7 Wireless. However, audio will only be heard
from one device at any one time. When two devices
are connected the other device can override the
active stream.
To pair a Bluetooth device with T7 Wireless follow
the steps described below.
• With T7 Wireless switched on, press and hold the
Bluetooth button for 2 seconds. The indicator
will flash and T7 Wireless will provide audible
feedback when it enters "pairing" mode.
Note: T7 Wireless will automatically exit from
Bluetooth pairing mode if no device is paired
within 5 minutes.
• Open the Bluetooth settings on the source device
and ensure Bluetooth is switched on. Once
discovered, Bowers & Wilkins T7 Wireless will
appear as an available Bluetooth device. Select
T7 Wireless and close the Bluetooth settings.
T7 Wireless Bluetooth indicator will flash as
pairing is underway and illuminate fully when
pairing is established. T7 Wireless will also provide
audible feedback when pairing is established.
Note: If your Bluetooth audio source device does
not support "simple" pairing and requests a four
digit code, enter '1234'.
2 seconds
Diagram 5
Bluetooth setup
Devices
Bowers & Wilkins T7
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents