Isgus PERFECT 2040 Operating Manual page 80

Hint
In order to use this function also for punch pairs, where the OUT
punch is made after the date change, the fixed break (non
accumulation) schedule must also be defined beyond date
change.
In the input routine possible time settings for the following day
are automatically marked with "+" in the 12 hours mode as well
as in the 24 hours mode (see the following example)
Example C: Limited working time beyond date change
Fixed break / non accumulation schedule
from Monday PM 11:00 to Tuesday AM 01:00.
Schedule
IN
Mo PM 07:00
= fixed break / no time accumulation
= presence time to be calculated
Hint
If there should be no calculation of IN-punches on Tuesday from
AM 00:00 to AM 01:00, it is necessary to enter a corresponding
fixed break (non accumulation) schedule for Tuesday.
Factory setting:
Proceeding
4-48 Getting Started
from = PM 11:00
Mo PM 11:00
→ function deactivated
Chapter 4
to = AM +01:00
OUT
Tu AM 00:30
= Activate the function
Or:
Switch to the next parameter
with "S".
= Confirm setting
Recorder changes to the next
input level.
Tu AM +01:00