Connection Of Accessories - POLTI VAPORETTO POCKET Instructions Manual

VAPORETTO POCKET - POCKET 2.0
steam delivery system by a child or other per-
sons unaware of how the device works. To
prevent the accidental output of steam press
the button (2A). To resume delivery press the
button (2A) in the opposite direction and ope-
rate the steam control lever (4) (Fig. 5).
The first jet of steam may contain some water
droplets, due to imperfect thermic stabilisation
inside the flexible hose. We would therefore
advise that the first jet of steam is played onto
an old cloth until a constant steam flow is
obtained.
NOTE: The steam pressure indicator (D) may go
on and off from time to time during use of
Vaporetto, this is quite normal
ATTENTION: If you press the steam request lever
(4) when the appliance is still under pressure,
even if it is off and not connected to the wiring
system, you may still experience steam escaping
from the flexible hose.
So when you switch off the appliance, before sto-
ring it, it is neccessary to press the lever (4) till the
steam flow is exhausted.

CONNECTION OF ACCESSORIES

• To connect the extension tubes (7) to the grip,
the large brush (8) and the adapter (5), simply
join them to one another until the accessory
locking button (11) clicks into place (Fig. 6).
• To release the accessories simply hold the but-
ton (11) down and separate the components
(Fig. 6).
• Before using the accessories, make sure that
they are firmly in place.
ATTENTION: To connect the accessories (6) and
(12), it is necessary to fasten the adapter first (5).
Once the adapter is secured in place, block the
accessory and lock it by turning it in the direction
of the arrow on it (Fig.7).
SAFETY CAP / LACK OF WATER
This appliance is equipped with a safety cap which
prevents the boiler being opened even accidental-
ly, until minimum pressure is reached inside. This
is indicated by a safety peg located on the cap
which, when it comes out of the cap (Fig. A), indi-
cates that there is still pressure inside the applian-
ce. When it goes back completely into the cap
(Fig. B), it indicates that there is no longer pressu-
re in the appliance.
Fig. A
ATTENTION - Risk of burns:
Never force the cap open and never operate
on the safety peg if the appliance is still on
and connected to the mains or if it is still hot
Every time you want to open the safety cap, pro-
ceed as follows:
• Switch off the appliance using the ON/OFF swit-
ch (B).
• Unplug from the mains electricity (F).
• Dispense steam until it is gone, using the steam
control lever (4) on the steam gun (2).
• Wait a few minutes to allow the boiler to cool.
• Unscrew the safety cap (A) anticlockwise.
• Refill it by following the description in Point 1 of
the PREPARATION paragraph.
WARNING: Not complying with this procedure
can expose you to the risk of burns.
PRECAUTIONS FOR DELICATE
SURFACES
• Before treating leather, special fabrics and
wood surfaces, consult the manufacturer's in-
structions and always carry out a test on a hid-
den part or on a sample of the material. Allow
the steamed part to dry to make sure that no
changes in colour or deformations have occur-
red.
• Please pay careful attention when cleaning
wooden and treated terracotta flooring as pro-
longed use of steam may damage the wax, po-
18
Fig. B