Cable-Winder; Care Of Your Appliance - POLTI VAPORETTO POCKET Instructions Manual

VAPORETTO POCKET - POCKET 2.0
with a double-folded cotton cloth.
For furniture cleaning direct the steam jet onto a
dry cotton cloth, and then clean with the cloth. The
warm moisture on the cloth traps the dust, spots
and the static electricity so that the furniture stays
clean longer as there is no detergent film for new
dust to stick to.
The following two accessories can be applied to
the small brush:
12A – Cloth for small brush: Fit the cloth over
the small brush and clean the surfaces to be trea-
ted.
12B – Window-cleaning tool for small brush:
Apply the tool to the small brush (without the cloth
(12A)) as shown in Figure 8.
Window-cleaning is carried out in two stages:
• Deliver of steam onto the surface to be cleaned,
by operating the steam delivery lever (4), to dis-
solve the dirt;
• Pass the window-cleaning tool over the surface
to remove the dirt, without delivering any more
steam.
LANCE (6)
To connect the lance to the sheath or to the exten-
sion tubes, the adapter for connecting small
accessories (5) must be fitted first, after which the
accessory can be connected directly to the adap-
ter. The lance can be used to direct the flow of
steam towards hidden corners that are difficult to
reach with the steam sprayer. It is ideal for clea-
ning radiators, door and window jambs, sanitary
fixtures and shutters. It is an extremely useful and
indispensable accessory.
The following accessories can be fitted to the
lance:
6A – Curved tip for lance: suitable for reaching
even more inaccessible points, thanks to its cur-
ved shape.
6B - Small round brush and 6C - Large round
brush: suitable for removing caked dirt from very
narrow surfaces such as cooker burners, roller
shutters, joints between tiles, sanitary fixtures, etc.
It is possible to choose the most suitable brush
depending on the size of the surface to be clea-
ned.
To connect accessories 6A-6B or 6C to the lance
(6), simply fit these accessories onto the tip of the
lance exerting a slight pressure (Fig.9).
TRANSPORT
One of the great advantages of this device is that
it can be carried anywhere, thanks to the handle
(H) or the shoulder strap (13).
ATTENTION: Some HOT water may leak out of
the accessories mixed with the steam, especially
when the tank has just been filled, while carrying
out the cleaning operations and as a consequen-
ce of movement of the device.

CABLE-WINDER

When putting Vaporetto away, it is possible to
wind the cable underneath it. To wind the cable,
turn the black pin on the front of the bottom part of
the device and wind the cable as shown in Fig.10.

CARE OF YOUR APPLIANCE

• Before carrying out any maintenance on the
device, always unplug it from the power mains
making sure that the product has cooled down
before proceeding.
• After using the brushes, we recommend letting
the bristles cool down in their natural position, in
order to avoid any deformation.
• To clean the body of the appliance, simply use
a moist cloth.
• Clean accessories by rinsing them in running
water.
• Regularly check the status of the coloured
washer located in the connector assembly
(3). If necessary, replace with the appro-
priate spare part (14), as described below.
Fig. C
- Remove the damaged washer.
- Insert the new washer, placing it on the steam
nozzle and pushing it until it is in its place. See
(Fig. C)
- Lubricate the gasket with silicone grease or Va-
seline, or alternatively with small quantities of
vegetable oils.
Carry out the same inspection on the connec-
tion seals of the steam gun (2), and the adapter
for connecting small accessories (5).
20