Mitsubishi Electric TC-24A Setting Manual page 3

Initial Settin g s
3
[Notes on using the TC-24A with the AG-150A controllers*]
In addition to making the group and interlock settings on the TC-24A, the same setting information must be entered on the AG-150A
controllers. Also, enter the M-NET address for the TC-24A in the System Controller field on the Group Setting screen. Register the
M-NET address of the AG-150A on the TC-24A's Group Setting screen.
When combining TC-24A with the AG-150A controllers, the Setback, Hold, and External Input Function settings should be made
only on the TC-24A. If using the Hold function on the TC-24A, schedule settings should not be made on the AG-150A controllers.
To prohibit the operation of local remote controllers, set the prohibition settings either from the TC-24A or AG-150A, but not both.
* AG-150A Controllers : AG-150A, GB-24A, GB-50A, G-50A
(1) Initial startup settings:
Before turning on the controller, first make sure that the controller, indoor units, and outdoor units have been installed
properly according to the instructions detailed in the respective manuals.
Turn on the controller and the units.
3
(a) The Language screen will appear
Select the display language.
Touch the button to select the language of your choice.
Touch the OK button.
(b) The Date and Time screen will appear.
Set the current date on the Date tab, and set the current time on the Time tab,
using the ▼ and ▲ buttons to change the values.
Click on the checkbox next to the date/time format of your choice.
Touch the Save button to save the settings.
(c) The Service Menu screen will appear.
Touch the Initial Settings/Basic System button to set the basic settings for the
controller. (Refer to section 3(2)-1 for details.)
When the settings have been chosen, touch the Initial Settings/Groups button.
(d) The Initial Settings/Groups screen will appear.
Touch the Groups button to make the group settings. (Refer to 3(2)-2 for
details.)
Touch the Interlocked LOSSNAY button to make the interlocked operation
settings. (Refer to 3(2)-3 for details.)
The initial startup settings are now complete.
Touch HOME button [
Touch the OK button on the popup screen to start the initialization process.
(e) The message (shown left) will appear on the screen, displaying the
initialization progress. When initialization is complete, the screen will
automatically return to the HOME screen.
(Initialization will take up to five minutes.)
* To change settings later, perform a test run, or verify the maintenance
information
Touch MAIN MENU button [
Touch SERVICE MENU button [
Enter the password to log on to the Service Menu screen.
(Refer to Chapters 3, 4, and 5.)
] at the top right corner of the screen.
] on the HOME screen.
] on the Main Menu screen.