Names Of Each Part - Hitachi ED-X31EP Service Manual

3. Names of each part

Projector
(1) Lamp cover
The lamp unit is inside.
(2) Focus ring
(3) Zoom ring
(4) Control panel
(5) Elevator buttons (x 2)
(6) Elevator feet (x 2)
(7) Remote sensor
(8) Lens
(9) Lens cover
(10) Intake vents
(11) Filter cover
The air filter and intake vent are
inside.
(12) Speaker
(13) Exhaust vent
(14) AC inlet
(15) Power switch
(16) Rear panel
(17) Security bar
(18) Security slot
WARNING
or just after use, since it is too hot.
Do not look into the lens or vents while the lamp is on, since the strong light is not good for your
eyes.
Do not handle the elevator buttons without holding the projector, since the projector may drop
down.
CAUTION
cover, block or plug up the vents. Do not place anything that can stick or be sucked to the vents,
around the intake vents. Clean the air fi lter periodically.
Do not use the security bar and slot to prevent the projector from falling down, since it is not
designed for it.
ED-X31E / ED-X33E (C14B-20)
HOT! : Do not touch around the lamp cover and the exhaust vents during use
Maintain normal ventilation to prevent the projector from heating up. Do not
HOT!
(1)
(6)
(8)
(9)
(6)
(13)
HOT!
(4)
(18)
(16)
(17)
(13)
4
(2) (3) (4)
(11)
(10)
(5)
(7)
(6)
(6)
(10)
(11)
(12)
(14)
(15)
(1)