Table of Contents
Advertisement
1MRK 504 160-UEN -
1.4.2
Transformer protection RET650 2.1 IEC
Commissioning manual
a hazard which could result in corruption of software or damage to
equipment or property.
The information icon alerts the reader of important facts and
conditions.
The tip icon indicates advice on, for example, how to design your
project or how to use a certain function.
Although warning hazards are related to personal injury, it is necessary to understand
that under certain operational conditions, operation of damaged equipment may result
in degraded process performance leading to personal injury or death. It is important
that the user fully complies with all warning and cautionary notices.
Document conventions
•
Abbreviations and acronyms in this manual are spelled out in the glossary. The
glossary also contains definitions of important terms.
•
Push button navigation in the LHMI menu structure is presented by using the
push button icons.
For example, to navigate between the options, use
•
HMI menu paths are presented in bold.
For example, select Main menu/Settings.
•
LHMI messages are shown in Courier font.
For example, to save the changes in non-volatile memory, select Yes and press
.
•
Parameter names are shown in italics.
For example, the function can be enabled and disabled with the Operation setting.
•
Each function block symbol shows the available input/output signal.
•
the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
•
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to
achieve a valid application configuration.
•
Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
•
Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST or LHMI.
•
If an internal signal path cannot be drawn with a continuous line, the suffix
-int is added to the signal name to indicate where the signal starts and
continues.
•
Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix "-cont."
Section 1
Introduction
and
.
11
Advertisement
Table of Contents
