Document Revision History; Related Documents - ABB RET650 2.1 IEC Commissioning Manual

Transformer protection

Table of Contents

1MRK 504 160-UEN -

1.3.2

1.3.3

Transformer protection RET650 2.1 IEC

Commissioning manual

well as verifying settings by secondary injection. The manual describes the process of

testing an IED in a station which is not in service. The chapters are organized in the

chronological order in which the IED should be commissioned. The relevant

procedures may be followed also during the service and maintenance activities.

The operation manual contains instructions on how to operate the IED once it has been

commissioned. The manual provides instructions for the monitoring, controlling and

setting of the IED. The manual also describes how to identify disturbances and how to

view calculated and measured power grid data to determine the cause of a fault.

The application manual contains application descriptions and setting guidelines

sorted per function. The manual can be used to find out when and for what purpose a

typical protection function can be used. The manual can also provide assistance for

calculating settings.

The technical manual contains operation principle descriptions, and lists function

blocks, logic diagrams, input and output signals, setting parameters and technical

data, sorted per function. The manual can be used as a technical reference during the

engineering phase, installation and commissioning phase, and during normal service.

The communication protocol manual describes the communication protocols

supported by the IED. The manual concentrates on the vendor-specific

implementations.

The point list manual describes the outlook and properties of the data points specific

to the IED. The manual should be used in conjunction with the corresponding

communication protocol manual.

The cyber security deployment guideline describes the process for handling cyber

security when communicating with the IED. Certification, Authorization with role

based access control, and product engineering for cyber security related events are

described and sorted by function. The guideline can be used as a technical reference

during the engineering phase, installation and commissioning phase, and during

normal service.

Document revision history

Document revision/date

January 2016