5: Selecting The Speaker System - Sony TA-DK2 Operating Instructions Manual

Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAU011 remote commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the amplifier, replace all the batteries with
new ones.
5: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the amplifier for
this operation.
KEY
HIGH HIGH
CONTROL
?/1
MID MID
DISPLAY
KARAOKE
ON/OFF VOCAL
LOW LOW
SELECT
ECHO LEVEL
MIC 1 VOL MIC 2 VOL
SCORE
ECHO ECHO
MIN MAX MIN MAX MIN MAX
DELAY REPEAT
MIC 1 MIC 2
KARAOKE
SPEAKERS (OFF/A/B/A+B)
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
To select
The speakers connected to the
SPEAKERS FRONT A terminals
The speakers connected to the
SPEAKERS FRONT B terminals
The speakers connected to both the
SPEAKERS FRONT A and B
terminals (parallel connection)
To turn off the speaker output, press
SPEAKERS (OFF/A/B/A+B) repeatedly until
the "SP A" and "SP B" indicators on the
display do not light up.
Note
Be sure to connect front speakers with a nominal
impedance of 12 ohms or higher if you want to select
both sets (A+B) of front speakers.
HIGH
D.B.F.B. MASTER VOLUME
MID
LOW
MUTING
MUSIC VOLUME
INPUT SELECTOR
BALANCE SPEAKERS
L R (OFF/A/B/A+B)
Light up
SP A
SP B
SP A and
SP B
17 GB