Mechanical Characteristics; Mechanical Data Files; Location Of Philips Logo; Gap Between Panel And Front Bezel - Philips 190V1SB/93 Service Manual

更多难得资料请到江南家电维修论坛免费下载！
http://bbs.520101.com
72 72
Meridian 1
5

Mechanical characteristics

5.1 Cosmetic

5.2 Mechanical data files

5.3 Location of Philips Logo

5.4 Gap between panel and front bezel

5.5 Location of Control Icons

5.6 Color for resin/paint

5.7 Resins

•
RoHS required
•
WEEE required.
•
Resin type/selection refers to Project Book Section 7.2 Plastic material.

5.8 If paint is used

•
RoHS required
•
WEEE require
•
If new painting type needs to implement, refer to UN-D 1235.

5.9 Plastic mold tooling

•
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to "TYV61-90007".
•
Painting to cover up cosmetic defects due to molding is strongly discouraged.
•
China RoHS mark requested.

5.10 Plastics flammability

•
All Plastics to be Flame Retardant UL 94-HB.
•
Base / Rear to be Flame Retardant UL 94-HB
•
All major plastic parts (bezel, back cover) need to be molded from same resin. Plastic resin type selection
should be referred to "TY R83-2-9002-1".

5.11 Texture/Glossing of housing

•
The texture area and texture no should follow Philips make-up sheet.
•
The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
•
Detail document for texture refer to "UN-D249", "UN-D 600".
•
> = 80 gloss units
Philips ID
ProE files required
Per Philips make-up sheet
< 1.4mm (typ.)
Per Philips Graphic sheet
Per Philips make-up sheet