Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Preparing the Machine
No Parts Required
Procedure
1. Move the machine to a level surface and set the parking
brake.
2. Stop the engine, wait for all moving parts to stop, and
remove the key.
WARNING
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
Description
No parts required
Snowthrower housing
Discharge-chute assembly
Deflector shield
Carriage bolt
Washer
Locknut
Cable guide
Chute control bracket
Knob
Handle clamp (200/300 series only)
Washer, large (200/300 series only)
Washer, small (200/300 series only)
Mounting bracket (TX series only)
Self-tapping screws (5/16 x 3/4 inch)
(TX series only)
Retaining plate (TX series only)
Qty.
–
1
1
1
Install the discharge chute.
3
3
3
Install the cable guide (200/300 series
1
traction units only).
1
2
1
1
Install the snowthrower.
1
1
2
1
7
Use
Advertisement
Table of Contents
