Safety Instructions - Hilti POL 10 Operating Instructions Manual

Specification
Telescope image
Magnification
Shortest distance to target
Lens aperture
Field of view diameter
Multiplication constant (stadia)
Addition constant (stadia)
Compensator type
Working range (compensator)
Setting accuracy (compensator)
Sensitivity (circular bubble level)
Graduation (horizontal circle)
Graduation interval
(horizontal circle)
Dimensions (L x W x H)
Weight
Protection against dust and water
spray
Tripod thread
Operating temperature range
Storage temperature

5 Safety instructions

5.1 Basic information concerning safety
In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
5.2 General safety rules
a) Do not render safety devices ineffective and do
not remove information and warning notices.
b) Keep children away from this tool.
c) Take the influences of the surrounding area into
account. Do not use the tool where there is a risk
of fire or explosion.
d) Do not point the tool toward the sun or other
powerful light sources.
5.3 Proper organization of the work area
a) Avoid unfavorable body positions when working
from ladders. Make sure you work from a safe
stance and stay in balance at all times.
b) Measurements taken through or from panes of glass
or through other objects may be inaccurate.
c) Ensure that the tool is set up on a steady, level
surface (not subject to vibration).
d) Use the tool only within its specified limits.
POL 10
Vertical
20x
0.65 m (2.1 ft)
30 mm (1.18 in)
1°20' (2.30 m / 7.5 ft)
100
0
x-form; wire-suspended,
air-damped
± 15'
0.5"
8': 2 mm (0.08 in)
360°
1°
190 x 130 x 136 mm
(7.5 x 5.1 x 5.4 in)
1.80 kg (3.97 lbs)
IP 55 as per IEC 529
⁵/₈ in
-20...+50°C (-4°F to 122°F)
-30...+60°C (-22°F to 140°F)
e) Use the tool and its accessories etc. in accord-
ance with these instructions and in the manner
intended for the particular type of tool. Take the
working conditions and the work to be performed
into account. Use of tools for applications differ-
ent from those intended could result in a hazardous
situation.
f) Use of the telescopic staff in the vicinity of over-
head high voltage cables is not permissible.
5.3.1 Electromagnetic compatibility
Although the tool complies with the strict requirements of
the applicable directives, Hilti cannot entirely rule out the
possibility of interference to the tool caused by powerful
electromagnetic radiation, leading to incorrect operation.
5.4 General safety rules
a) Check the condition of the tool before use. If the
tool is found to be damaged, have it repaired at a
Hilti service center.
POL 15
Vertical
28x
0.65 m (2.1 ft)
36 mm (1.40 in)
1°20' (2.30 m / 7.5 ft)
100
0
x-form; wire-suspended,
air-damped
± 15'
0.5"
8': 2 mm (0.08 in)
360°
1°
190 x 130 x 136 mm
(7.5 x 5.1 x 5.4 in)
1.80 kg (3.97 lbs)
IP 55 as per IEC 529
⁵/₈ in
-20...+50°C (-4°F to 122°F)
-30...+60°C (-22°F to 140°F)
en
9