Maintenance Preparations; Seat Removal/Installation; Fuel Tank Removal - Honda CR125R 2004 Owner's Manual

MAINTENANCE PREPARATIONS

SEAT
Seat Removal
1. Remove the seat bolts and collars.
2. Slide the seat back.
(1) SEAT BOLTS/COLLARS
Seat Installation
1. Slide the seat front prong onto the seat bracket and
the seat rear prong onto the tabs by pushing down
and forward on the seat in each of these areas.
2. Install the collars and seat bolts.
TORQUE: 2.0 lbf·ft (26 N·m, 2.7 kgf·m)
1
2
4
(1) SEAT FRONT PRONG (2) SEAT BRACKET
(3) SEAT REAR PRONG (4) TABS
FUEL TANK

Fuel Tank Removal

1. Turn the fuel valve OFF.
2. Remove the seat (this page).
3. Remove the shroud A bolts/collars, B bolts/collars
and shrouds.
2
1
(2) SEAT
(1) SHROUD A BOLTS/COLLARS
(2) SHROUD B BOLTS/COLLARS
(3) SHROUD
4. Pull the breather tube out of the steering stem nut.
5. Unhook and remove the fuel tank band.
6. Remove the fuel tank bolt.
3
(1) BREATHER TUBE
(3) FUEL TANK BOLT
7. Disconnect the fuel line from the fuel valve.
8. Remove the fuel tank.
•
(1) FUEL LINE
(2) FUEL TANK BAND
The fuel line leading to the carburetor must be dis-
connected, not the fuel line leading to the fuel tank.
Gasoline is extremely flammable and is explosive
under certain conditions. Perform this operation in
a well-ventilated area with the engine stopped. Do
not smoke or allow flames or sparks in the area
where gasoline is drained or stored and where the
fuel tank is refueled.
(2) FUEL VALVE
17