Using Ac / Dc Signal Output - TESTO 816-1 Instruction Manual

Saving a measurement series
When measurement series storage is activated, most functions
(individual value storage, storage interval setting, frequency
weighting, time weighting) are deactivated.
1. Press the
-
2. Press the
- The storage of readings is completed.
Deleting a measurement series memory
1. Switch the instrument off.
2. Hold down the
- While the keys are held down:
and a countdown (5 seconds) starts.
3. Once the countdown is complete, release the keys.
- The memory is deleted.
Displaying a measurement series
Stored measurement series are displayed and evaluated via the
PC software, see 7.7 Data Logger, page 28.
5.12.

Using AC / DC signal output

Specifications
AC: 1 Vrms at full deflection, output impedance approx. 100 ohms,
output signal via standard 3.5mm jack plug (see illustration below).
DC: Output 10mV / dB, output impedance 1 kohm, output signal via
standard 3.5mm jack plug (see illustration below).
AC Signal
key.
lights up and the readings are stored.
key again.
key and the
DC Signal
Ground
5 Using the product
key.
CLr is displayed, SURE flashes
21