Troubleshooting - Electrolux ESL 7220RO User Manual

to use monthly a specific cleaning
product for dishwashers. Follow

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation, before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with
the help of the information in the table.
WARNING!
Repairs not properly done
may result in serious risk to
the safety of the user. Any
repairs must be performed
by qualified personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with wa‐
ter.
• The end indicator flashes 1 time
intermittently.
• Acoustic signal sounds 1 time in‐
termittently.
The appliance does not drain the
water.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times
intermittently.
carefully the instructions on the
packaging of the product.
With some problems the end indicator
flashes intermittently indicating a
malfunction.
The majority of problems that can
occur can be solved without the need
to contact an Authorised Service
Centre.
Possible cause and solution
• Make sure that the mains plug is connected
to the mains socket.
• Make sure that there is no damaged fuse in
the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance has started the procedure to
recharge the resin inside the water softener.
The duration of the procedure is approxi‐
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is
not clogged.
• Make sure that the inlet hose has no kinks
or bends.
• Make sure that the sink spigot is not clog‐
ged.
• Make sure that the drain hose has no kinks
or bends.
ENGLISH 17