Fiat Panda Owner's Handbook Manual page 16

❒ press the
adjustment;
GETTING TO
❒ press the
KNOW YOUR CAR
screen or hold the button down to return to the
standard screen without storing.
SAFETY
IMPORTANT The setting will increase or decrease
by one unit each time the
pressed. Holding the button down causes an
automatic rapid increase/decrease. Complete the
STARTING AND
adjustment with single presses of the button when
DRIVING
you approach the desired value.
See radio (audio information display)
WARNING LIGHTS
AND MESSAGES With this function the display shows information
about the sound system.
❒ Radio: selected radio station frequency or RDS
message, automatic tuning activation or
IN AN EMERGENCY
AutoSTore;
❒ Audio CD, MP3 CDs: track number;
❒ CD Changer: CD number and track number.
SERVICING AND
To show the sound system information on the
MAINTENANCE
display (On) or clear it (Off), proceed as follows:
❒ briefly press MODE button, ON or OFF flashes
TECHNICAL on the display according to the previous setting;
SPECIFICATIONS
❒ press the
❒ briefly press MODE button to go back to the
menu screen or press the button for a prolonged
time to go back to the standard screen without
INDEX
storing the settings.
12
or button to make the
button briefly to return to the menu
or button is
or button to select;
Autoclose (Automatic central locking with car
in motion)
When activated (On), this function locks the doors
automatically when the vehicle speed exceeds 20
km/h.
To activate or deactivate this function, proceed as
follows:
❒ press the
button briefly to make the display flash
"On" or "Off" according to the previous setting;
❒ press the
or button to select;
❒ press the
button briefly to return to the
submenu screen or hold the button down
to return to the main menu screen without saving;
❒ hold the
button down again to return to the
standard screen or to the main menu according
to where you are in the menu.
Measurement unit (Setting the measurement
unit)
This function can be used to set the units through
three submenus: "Distances", "Consumption" and
"Temperature".
To set the desired unit of measurement, proceed as
follows:
❒ briefly press
to display the three submenus;
❒ press the
or button to navigate through
the three submenus;
❒ once you have selected the submenu to be
changed, press the button briefly;