Troubleshooting - Zanussi ZCV664FPB User Manual

2
1
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part
to the door. Refer to the image.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
Residual heat indicator does not
come on.
20
A
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the back
of the cavity.
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Check if the appliance is correct-
ly connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Remedy
www.zanussi.com