Table of Contents
Advertisement
The lamp glass cover is at the back
of the cavity.
1. Turn the lamp glass cover counterclockwise
to remove it.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
Residual heat indicator does not
come on.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle
on the food and in the cavity of
the oven.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
www.zanussi.com
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
We recommend that you write the data here:
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Check if the appliance is correct-
ly connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
Remedy
19
Advertisement
Table of Contents
