Energy Efficiency - Zanussi ZCV664FPB User Manual

Covering terminal board
• The recommended cross-section area is six
square millimetres (6 mm²).
• When you refit the mains terminal cover,
make sure that the lower tabs are located
inside the bottom edge of the aperture,
before you fix the two screws into the top
edge of the mains terminal cover.
• Make sure that the cover is securely
fastened.

Energy efficiency

Product information for hob according to EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
Diameter of circular cooking zones
(Ø)
Energy consumption per cooking
zone (EC electric cooking)
Energy consumption of the hob (EC electric hob)
EN 60350-2 - Household electric cooking
appliances - Part 2: Hobs - Methods for
measuring performance.
Hob - Energy saving
You can save energy during everyday cooking if
you follow below hints.
• When you heat up water, use only the
amount you need.
www.zanussi.com
Terminal board
Make sure that the links are fitted as shown.
ZCV664FPB
ZCV664FPW
ZCV664FPX
Hob inside Freestanding Cooker
4
Radiant Heater
Left front
Left rear
Right front
Right rear
Left front
Left rear
Right front
Right rear
• If it is possible, always put the lids on the
cookware.
• Before you activate the cooking zone put the
cookware on it.
• The cookware bottom should have the same
diameter as the cooking zone.
• Put the smaller cookware on the smaller
cooking zones.
• Put the cookware directly in the centre of the
cooking zone.
To open the cover of terminal board
obey the procedure in opposite
sequence.
Do not remove blanking plates.
L L N
18.0 cm
14.5 cm
14.5 cm
18.0 cm
177.3 Wh/kg
180.3 Wh/kg
180.3 Wh/kg
179.4 Wh/kg
179.3 Wh/kg
N N
23