Connecting to a network device
Connect one end of a network cable to the LAN port on the system rear panel
and the other end to a hub or switch.
Turning on the system
1.
Connect the supplied AC power cord to the system AC power inlet on the I/O
panel of the system.
2.
Connect the other end of the AC power cord to a corresponding outlet.
3.
Press the power switch to turn on the system
QDSP-2090 Series User's Manual
Figure 7 Network cable with RJ45 connector
Figure 8 Turning on the system
2x LAN
Chapter 2
DC Jack
Power Button