LG Signature AM501YWM1 Owner's Manual page 32

Intensive Cleaning of Water Bucket
Filters
1
Dissolve baking soda in water and soak the water
bucket filters in the solution for 30 minutes.
• Use 6 ½ tbsp. (100 g) baking soda in 2 ½ gal. (10 L)
water.
10L
(2 ½ gal.)
60L 10L
2
Scrub the water bucket filters with a toothbrush or soft
brush to remove any foreign objects.
3
Thoroughly rinse the filters to remove any baking soda
residue.
4
If the filters are to be used immediately, shake off
excess water and reassemble. If storing the product
or not using it immediately, place the filters in a sunny
spot and allow to dry completely.
32
UG_enUS_esXL.indb 32
100 g
(6 ½ tablespoons)
Caution
• If any detergent residue remains on the filter, it may
cause sudsing or odor during operation.
• Use of neutral detergent may result in severe sudsing.
For this reason, baking soda is preferred.
Assembling Water Bucket
After cleaning or filling the water bucket, reassemble it as
follows:
1
Mount the water bucket filters in the water bucket.
• First place the side filter in the bucket, then the top
filter, aligning the arrow on the filter with the arrow
on the water bucket.
• If the filters do not mount easily in the bucket, lift
and realign them until they lower easily into place.
2
Use the handle to carefully lower the water bucket into
the body of the product.
• Make sure the bucket is aligned so that the contact
connectors on the body slide through the slot in the
top of the bucket.
2017-05-25 1:52:00