Access Camera - ERNITEC Mercury SX4 series User Manual

4.

Access Camera

For initial access to the IP camera, users can search the camera through the
installer program: DeviceSearch.exe, which can be found in "DeviceSearch"
folder in the supplied CD.
Accessing the Camera by Device Search Software
Step 1: Double click on the program Device Search.exe.
1.
Step 2: After its window appears, click on the <Device Search> button on
Step 3: Find the camera in the list by its IP address and click on it. The
2.
Step 4: The default IP address of the camera may not be in the same LAN
3.
Step 5: The <Network Setup> page will come out. Select <DHCP> and click
Step 6: Click <OK> on the Note of setting change. Wait for one minute to re-
Step 7: Click on the <Device Search> button to re-search all the devices.
V 3.01.090117
the top. All the finding IP devices will be listed in the page.
default IP address of the camera is: 192.168.0.250.
as the IP address of the PC. If so, the IP address of the camera
needs to be changed. Right click on the camera and click <Network
Setup>. Meanwhile, record the MAC address of the camera for
future identification.
<Apply> down the page. The camera will be assigned with a new IP
address.
search the camera.
Find the camera in the list by its MAC address. Then double click or
right click and select <Browse> to access the camera directly via a
web browser.
© 2016 Ernitec. All rights reserved
www.ernitec.com
User's Manual – Mercury SX4 series
10