Table of Contents
Advertisement
6. Installation
6.1 Cable layout
Two different cable layouts are possible:
Concealed cabling
If you wish to conceal the connection cable, drill a hole of appropriate size at the location where the
camera will be mounted. Now pull the connection cable through the opening; the camera mount will
conceal the cable opening.
Surface cabling
If you wish to lay the connection cable along the surface,
you can use the cable opening on the base plate of the
camera mount.
6.2 Installing the camera
IMPORTANT!
The camera must be disconnected from the mains power during installation.
Note
You can remove the sunshield by releasing the fastening screw at the top of the
camera.
6.2.1.
Position the camera in a
suitable place, and lay the
cabling as described under 6.1.
Mark and then drill the holes
required to install the camera.
Use the installation material
provided to fasten the camera in
place.
21
Advertisement
Table of Contents
