Gemini 4100 Instruction Manual page 56

APPENDIX "D" - GEMINI DUAL COUNTER MODE FUNCTION COMMAND CODE SUMMARY
CODE MODE
41 UNIT PERSONALITY
+/-2 Dual Counter*
42 RESET BUTTON & TERMINAL ACTUATION MODES
1 Reset Counter A
2 Reset Counter B
3 Reset Counter A & B
43 INPUTS 1 & 2 RESPONSE MODES
1 Count With Inhibit
2 Count With Up/Down Control
3 Add/Subtract
4 Separate Inputs
5 Quadrature
6 Quadrature x4
44 COUNTER A & B NUMBER OF COUNT EDGES
1 Single Edge Counting (x1)
2 Double Edge Counting (x2)
45 COUNTER B SCALE MULTIPLIER
1 1
2 0.1
3 0.01
4 0.001
46 CNTR B DECIMAL POINT & LEAD ZERO BLANKING
(+) Leading Zero Blanking Enabled
(-) Leading Zero Blanking Disabled*
+/-1 No Decimal Point
+/-2 Decimal Point Right of Digit 2
+/-3 Decimal Point Right of Digit 3
+/-4 Decimal Point Right of Digit 4
+/-5 Decimal Point Right of Digit 5
+/-6 Decimal Point Right of Digit 6
* Polarity sign is displayed in front of the identifier, a (-) sign is displayed, a (+) sign is not.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DESCRIPTION COMMENTS
(-)Loads factory set code values*
Counter A→Display value (A)/Counter B→Display value (B)
Reset affects the outputs as well as the displayed value.
Input 1 = Cnt A & Cnt B, Input 2 = Inh.
Input 1 = Cnt A & Cnt B, Input 2 = Up/Dn.
Input 1 = Add, Input 2 = Subtract
Input 1 = Counter A, Input 2 = Counter B
Input 1 = Cnt A & Cnt B, Input 2 = Quadrature
Input 1 = Cnt & Quad, Input 2 = Cnt & Quad.
Cannot be programmed in quadrature x4.
Count on falling edge of count input.
Count on both edges of count input