Advertisement
Hints for best reception:-
-
The receiver has a built-in bar antenna. If AM reception is weak. Slightly rotate or re-positioning of the unit
AM :
will usually improve the AM reception.
The receiver has a built-in FM Wire Antenna (26) hanging at the rear cabinet. This wire should be totally
-
FM :
unraveled and extended for best reception.
Listening to Phono
NOTED:
-
Remove the stylus protector.
-
Be sure that the tone arm is detached from the tone arm rest before
-
operating and re-secured again after wards.
1. Select to "Phono" function from Function Selector(7)
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter(use the Spindle Adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will
start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of the record, the platter will automatically stop rotating. Lift the tone arm
from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last track
REMARK :
finish. In this case, select the Auto-Stop Switch (22) to "Off" position. Then it will run to the end of the record but will
not stop automatically.(Turn off the unit by power button or switch back the Auto-Stop Switch (22) to "On" position to
stop the platter rotate). Then put back the tone arm to the rest position.
Remark : Due to Aux and Phono were designed at the same position of this system. When Aux in jack (24) plugged
by 3.5mm plug. The channel will change to Aux automatically and turntable will stop rotating. Please ensure the Aux
in jack (24) without plugged by anything before playing Phono.
Aux-in connection
Connect the unit to other device by connecting the Aux in jack (24) with a 3.5mm cable(not provided) and other end
connect to the external device such as Discman/MP3 player to perform the music playback or encoding function etc.
1. Slide the Function knob (7) to Phono/Aux position.
2. Adjust the Power ON-OFF/ Volume Control Knob (17) to desired volume level.
3. Start to play your external device.
Playback of MP3 via USB storage media
Connecting
The system is able to decode and playback all MP3 file which are stored on the memory media with USB connecting
port.
Function knob (7) to USB mode.
1.
Turn the
2. Plug-in the USB with the face up and make sure it is fully inserted.
z
Connecting the USB upside down or backwards could damage the audio
system or the storage media (USB thumb device). Check to be sure the
direction is correct before connecting.
3. The system will start reading and playback of the file on the storage media starts
automatically after inserting and the Play LED indicator (14) will light up .
Remark : USB port does not support connection with USB extension cable and is not designed to
communicate with computer directly.
2
Advertisement
