SAFETY INSTRUCTIONS 1. Read these instructions - All the safety and operating instructions should be read before this product is operated. 2. Clean only with a dry cloth. 3. Do not block any ventilation openings. Keep at least 5 cm around the apparatus for sufficient ventilations.
SPECIFICATIONS Belt Drive Turntable System Ceramic Cartridge Speaker Impedance: 4 Ohm Maximum USB Flash Support Size: 32GB Power: 100/240V (DC 9V Adapter) Unit Dimensions (L x W x H): 13.8’’ x 10.2’’ x 4.7’’ ...
TURNTABLE LAYOUT TURNTABLE PLATTER 16. POWER ADAPTOR JACK TURNTABLE SHAFT 17. LINE OUT JACK 45 RPM ADAPTOR 18. PLAY/PAUSE BUTTON LIFT LEVER 19. BACK BUTTON TONE ARM CLIP 20. NEXT BUTTON TONE ARM 21. RECORD BUTTON SPEED SELECTION SWITCH 22. STOP BUTTON LINE-IN (AUX-IN) JACK 23.
TURNTABLE OPERATION POWER SUPPLY Insert the adaptor plug into the DC IN jack on the rear of the unit, then connect the AC/DC adaptor (9V, 1A AC100-240V, 50-60Hz) to a AC/DC wall outlet. DC IN BASIC OPERATION 1. Lift the BUCKLE on the front of the turntable and open the lid. 2.
TURNTABLE OPERATION 4. Open the TONE ARM CLIP to release the TONE ARM. Push the LIFT LEVER backwards to raise the arm. Gently move the tone arm to the desired position over the record. The turntable will begin to spin when the arm is moved toward the record. Push the lift lever forward and lower the arm slowly onto the desired position on the record to begin playing.
An external (auxiliary) audio source (i.e. personal CD/MP3 Player/Mobile phone or computer) can be connected to this apparatus via the LINE IN JACK. 1. Plug a detachable AUX Cable (not provided) into the LINE IN socket on the function panel of the apparatus. 2.
USB/ SD CARD OPERATION Power on the unit. Set the function switch to USB/SD. Insert the USB disk into the USB port on the right panel, it will play automatically. 1. STOP When playing or pausing, press STOP, it will enter stop mode. 2.