MATTRESS FIRM 100 I/C-UBL Owner's Manual page 13

Reprogram Two Remote Controls for Individual
Base Operation - Bases are factory programmed
to operate individual bases. To reprogram bases
synced to multiple remote controls, perform the
following numbered procedure. Individual base
operation will result. If programming fails, initiate
the programming procedure a second time.
steP 1
UNPLUG both bases from the electrical power
source (if plugged in) and wait 3 minues.
steP 2
Plug base 1 into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
steP 3
Simultaneously press and hold the head up and
foot up buttons on remote control 1 for 2 seconds.
Release both buttons.
Press the head up or foot up button on remote
control 1 to verify base 1 functions.
steP 4
Plug base 2 into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
steP 5
Simultaneously press and hold the head up and
foot up buttons on remote control 2 for 2 seconds.
Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base 2 functions.
Independent operation is now restored. Remote control
1 operates base 1; remote control 2 operates base 2.
REMOTE CONTROL 1
REMOTE CONTROL 2
reMote ControL PrograMMIng
BASE 1
BASE 2
100 I/C-UBL Adjustable Base Owners Manual 290-0029
13