MATTRESS FIRM 100 I/C-UBL Owner's Manual page 12

Program Two Remotes to Operate One Base - Bases
are factory programmed to operate individual
bases. To program two remotes to operate one
base, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
steP 1
UNPLUG the base from the electrical power source
(if plugged in) and wait 3 minutes.
steP 2
Plug the base into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
steP 3
Simultaneously press and hold the head up and
foot up buttons on remote control 1 for 2 seconds.
Release both buttons and set remote control 1 aside
without pressing any other button.
NOTE: If any button is pressed, remote control will
exit pairing mode.
steP 4
Simultaneously press and hold the head up and
foot up buttons on remote control 2 for 2 seconds.
Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base functions.
Wait 5 seconds and press the head up or foot up
button on remote control 1 to verify base functions.
NOTE: There should be a 5 second wait time while
switching between remote control 1 and remote
control 2.
Two remote controls are now programmed to operate
one base.
REMOTE REMOTE
CONTROL 1 CONTROL 2
12
100 I/C-UBL Adjustable Base Owners Manual 290-0029
reMote ControL PrograMMIng
Program Two Remotes to Operate Two Bases -
Bases are factory programmed to operate individual
bases. To program two remotes to operate two
bases, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
steP 1
UNPLUG both bases from the electrical power
source (if plugged in) and wait 3 minutes.
steP 2
Plug both bases into the electrical power source.
You now have 3 minutes to complete the
programming procedure. The programming indicator
(under bed light) will flash to indicate programming
mode.
steP 3
Simultaneously press and hold the head up and
foot up buttons on remote control 1 for 2 seconds.
Release both buttons and set remote control 1 aside
without pressing any other button.
NOTE: If any button is pressed, remote control will
exit pairing mode.
steP 4
Simultaneously press and hold the head up and
foot up buttons on remote control 2 for 2 seconds.
Release both buttons.
Press the head up or foot up button on remote
control 2 to verify base functions.
Wait 5 seconds and press the head up or foot up
button on remote control 1 to verify base functions.
NOTE: There should be a 5 second wait time while
switching between remote control 1 and remote
control 2.
Two remote controls are now programmed to operate
two bases.
REMOTE REMOTE
CONTROL 1 CONTROL 2
BASE 1
BASE 2