Loop Termination Pcb; Audible Driver - Siemens ST750 Configuration Handbook

Replacement Card uses a standard detector backplane and will therefore allow the controller to
interface with up to four wireless sensors.
The Loop Detector Replacement Card provides a bridge between the Sensys equipment (access
point, repeater and sensor) and the traffic controller and may be used as a direct replacement for
loop detector cards.
Each of the Detector Replacement Cards plugs directly into the backplane. The power at the
backplane must be derived from an appropriate power supply (e.g. 50VA LV Detector
Transformer Kit, 667/1/27853/000), refer to paragraph
Detector Replacement Cards should be ordered at controller configuration time, to suit the
configuration required.
The final configuration and commissioning of the Detector Replacement Card outputs and the
interface with street installed equipment should be sought from the WiMag Detection System
General Handbook (667/HB/47200/000).

Loop Termination PCB

4.12
Loop termination is carried out in the Rack Assembly on the ST750LV. Refer to paragraph 4.2.

Audible Driver

4.13
The Audible and Tactile power supplies on the ST750LV are designed to provide a DC voltage
between 10V and 24V, and typically provide a maximum of 100mA at 18V DC. The ST750LV
provides three audible activation signals on the pedestrian phases.
Security classification
Version
Last Editor
Document Name
Copyright © Mobility 2017. All Rights Reserved.
Figure 93
Error! Unknown document
property name.
008
Nathan Fearnhead
Configuration Control
Mobility is a division of Siemens Plc
Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
4.16 for more information.
76 of 76
Page
Released
Status
16/06/2017
Date
667/CC/32750/000
Document No.