Cpu Pcb - Siemens ST750 Configuration Handbook

3.2.5 CPU PCB

The CPU PCB will be configured with the appropriate firmware for the variant of Outercase
specified. The CPU PCB in completely contained within a sub division of the ST750ELV
Backplane Rack Assembly, and is mounted vertically. The CPU PCB is connected to several
other PCBs, within the ST750ELV Backplane Rack Assembly and to external units.
A 34 way ribbon cable from the manual control panel is connected into the central 34 way socket
at the rear of the CPU PCB, connector X2.
The 16 way Molex plug at the bottom rear of the CPU PCB, connector X4, is connected to PL7 on
the Backplane Board.
Communications between the CPU PCB and Intelligent Detector Backplanes, detailed in
paragraph 6.7, are carried out via a high speed serial link, over RJ45/Cat 5 cable. Connection of
this serial link from the processor is carried as follows:
- PL1 on the PHS processor daughter board (part of the CPU PCB) is connected to SK10
on the Backplane Board.
- PL4 on the PHS processor daughter board is connected to SK11 on the Backplane Board.
- PL2 on the PHS processor daughter board is connected to serial IN socket on the first
Intelligent Detector Backplane. Refer to paragraph
Detector Backplane.
Note: An Input Output Expansion Kit can be specified, which also utilises the Fast Serial
Link. Please refer to section
PSU I/O Module
Security classification
Version
Last Editor
Document Name
Copyright © Mobility 2017. All Rights Reserved.
3.8 for information on Input Output Expansion Kit.
Figure 6
LSLS card
Error! Unknown document
property name.
008
Nathan Fearnhead
Configuration Control
Mobility is a division of Siemens Plc
Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
3.7 below for details on Intelligent
Backplane Board
Page
Status
Date
Document No.
Phase and
Phase return
Terminal Blocks
Audible and
Relay output
Terminal Blocks
Detector Power
Terminal Blocks
Digital input
Terminals
Blocks
17 of 73
Released
16/06/2017
667/CC/32750/000