Table of Contents
Advertisement
SMART AUDIO 400
Pairing the teacher microphone
To pair the teacher microphone
1. If the teacher microphone is turned on, turn it off by pressing and holding the
PWR/MUTE button for three seconds.
2. On the receiver, press the LINK button. The LINK LED flashes yellow.
3. On the teacher microphone, press and hold the PWR/MUTE and REC buttons.
A beep is heard through the speakers.
The BATT LED on the microphone and the LINK LED on the receiver light green.
Pairing the student microphone to the receiver
To pair the student microphone
1. If the student microphone is turned on, turn it off by sliding the TALK switch.
The BATT LED is unlit.
2. On the receiver, press the LINK button. The LINK LED flashes yellow.
3. On the student microphone, press and hold the PWR / LINK button and the TALK button.
A beep is heard through the speakers.
The BATT LED on the microphone and the LINK LED on the receiver light green.
Troubleshooting SMART Audio 400
Use the information below to troubleshoot your issues for the SMART Audio 400 classroom
amplification system.
Resolving issues with the microphones
Issue
The microphone is turned on and
paired to the receiver, but MIC1 or
MIC2 LED is not lit.
13
smarttech.com/kb/171144
Solutions
Check the pairing again. See Pairing the
microphones on the previous page.
Advertisement
Table of Contents
