Hot-plug SFF drive blank
o
To replace the SFF drive blank, while pressing the release latch, slide the component into the
bay until it is fully seated.
Hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Remove the front bezel (on page 25).
2.
Determine the status of the drive from the drive LED definitions
3.
page 84).
Remove the hot-plug drive.
4.
To replace the component, reverse the removal procedure.
4-bay LFF hot-plug drive cage
("Hot-plug drive LED
Removal and replacement procedures 30
definitions" on