Table of Contents
Advertisement
n Emergency
Places the transceiver into Emergency mode. Emergency mode is used to carry
out emergency actions.
Note:
◆ This function can be programmed only on the Side 1 key.
n Home Channel
Press this key to immediately select your home channel (pre-programmed by your
dealer).
n Home Channel Select
Hold down this key to set the current channel as the Home Channel.
n Key Lock
Press to lock/unlock the transceiver keys.
n Low Transmit Power
Each channel is programmed with either high or low transmit power. On high
transmit power channels, press this key to change the transmit power to low
power (you cannot change low transmit power channels to use high power).
n Lone Worker
Toggles Lone Worker mode ON and OFF.
n Monitor
Turns the transceiver signaling off, to listen to all calls that are received on the
channel. Press this key again to turn the transceiver signaling back on.
n Monitor Momentary
Turns the transceiver signaling off while holding down this key. Release this key to
turn the transceiver signaling back on. While signaling is off, you can listen to all
calls that are received on the channel.
n OVCM
Toggles OVCM (Open Voice Channel Mode) between ON and OFF.
n Paging Call
To transmit your PTT ID list, to request a call.
n Priority-channel Select
Press this key in normal mode to set the current channel as the Priority channel.
n Scan
Press this key to start scanning the transceiver channels.
10
Advertisement
Table of Contents
