Table of Contents
Advertisement
INSTALLING/ REMOVING THE BATTERY PACK
The battery pack is not charged at the factory; charge it before use.
CAUTION
◆ Do not short the battery terminals or dispose of the battery by fire.
◆ Never attempt to remove the casing from the battery pack.
INSTALLING THE BELT CLIP
Belt clip
CAUTION
◆ Do not use glue which is designed to prevent screw loosening when installing the belt
clip, as it may cause damage to the transceiver. Acrylic ester, which is contained in
these glues, may crack the transceiver's back panel.
1 Align the battery pack with the back of the
transceiver, then press the battery pack and
transceiver firmly together until the release latch on
the base of the transceiver locks.
2 To remove the battery pack, lift the safety catch on
the base of the transceiver, then press the release
latch underneath the safety catch.
3 While pressing the release latch, pull the battery
pack away from the transceiver.
If necessary, attach the belt clip using the two supplied
M3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its mounting location may get
hot during continuous transmission or when left sitting in a
hot environment.
5
Advertisement
Table of Contents
