Related Manuals for Black & Decker RD091216
Summary of Contents for Black & Decker RD091216
-
Page 1: A Battery Charger
20A BATTERY CHARGER INSTRUCTION MANUAL Cat. # BC20BDAU September 2016 RD091216 Printed in China BC20BDAU_Manual_091216.indd 12-1 9/12/2016 11:45:35 AM... - Page 2 BC20BDAU_Manual_091216.indd 2-3 9/12/2016 11:45:35 AM...
-
Page 3: Intended Use
INSTRUCTION MANUAL Inspection and repairs • In case of skin or eye contact, follow the instructions If liquid crystal gets into your eye: Flush the affected below. eye with clean water and then seek medical attention. • Before use, check the appliance for damaged or –... -
Page 4: Connecting The Battery Charger
• Position the battery charger as far away from the • If it is necessary to remove the battery from the may create a hazard. Make sure that adequate If the clamps are INCORRECTLY connected with battery as the leads will allow. The battery charger vehicle to charge or to clean the terminals, make preparation has been made before proceeding. -
Page 5: Checking The Battery Voltage
is adequate ventilation around the unit before When disconnecting the charger, disconnect the mains alternator. Run the engine long enough to achieve 2. If the unit detects that the alternator is good, the attempting to charge again. cord, remove clamp from vehicle chassis, and then normal idle speed and verify there is a no-load voltage. -
Page 6: Troubleshooting
2. Press the battery recondition button. The LCD revert to charging mode. To stop charging, press retailer where the product was purchased. They can and to be kept up to date on new products and special screen will display the following: the charge button again.