Table of Contents
Advertisement
Connections
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speaker
terminal (R)
Note:
Make sure that the AC
cord is locked on both
the left and right sides.
– Cable fixing band
Secure any excess cables with band as required.
Note:
One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fixing band through the
clip as shown in the figure.
1
SLOT1
Dual HDMI Terminals
(equivalent of Dual HDMI
Terminal Board (TY-FB10HMD))
(see page 11)
Note: At factory shipment, Terminal boards are installed in SLOT 1, SLOT 2 and SLOT 3.
8
AC cord connection (see page 12)
– AC cord fixing
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2
2
Fix the AC cord with
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fixing band around them
then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied fixing
band.
2
SLOT2
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of RCA Component Video
Terminal Board (TY-42TM6Z))
(see page 11)
Speaker
terminal (L)
Close
Push until
the hook
clicks.
Open
2. Pull
off.
1. Keep the
knob
pressed.
To tighten:
To loosen:
Push the catch
Pull
R
AUDIO
L
P
/C
/R P
/C
/B
Y/G
R
R
B
B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 9)
1
2
2
Unplug the AC cord
Unplug the AC
cord pressing
the two knobs.
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet first.
Pull
AUDIO
PC
IN
SERIAL
From SERIAL
Terminal on
Computer
(see page 10)
1
Advertisement
Table of Contents
