Electrical Connections - Panasonic CY-VM5800U Operating Instructions Manual

Electrical Connections
ka
ao XO c Y one og T T l
Cautions:
e This product is designed to operate off a 12 V DC, negative ground battery system.
e To prevent damage to the unit, be sure to follow the connection diagram below.
e Remove approx. '/4" (5 mm) of protective covering from the ends of the leads before connecting.
e Do not insert the power connector into the unit until the wiring is completed.
e Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
S 2@-
cables and keep cable terminals free from touching any metal parts.
e Note that if your car has a driving computer or a navigation computer, disconnecting the battery cables
may cause the contents of memory for these computers to be lost.
e The parking brake connection should be connected by a professional installer. In case of difficulty,
please consult your nearest authorized Panasonic Servicenter.
* All other installation methods require the use of dedicated metal fittings. Consult with a qualified servic-
ing engineer or your dealer if other methods are required.
O Wiring Diagram
Display unit
(1) Connection cord.
Remote control signal receiver lead
To the REMOTE-IN terminal or remote
control signal receiver lead of the
Panasonic DVD player (CX-DV700U).
Video input lead
To the video output connector of the
Panasonic DVD player (CX-DV700U).
ACC power lead
(Red) Fuse 3 A To ACC power, +12 V DC.
Ground lead
To a clean, bare metallic part of the car chassis.
SIDE BRAKE 4 Side brake (parking brake) connection lead
(Blue/yellow stripe) Be sure to wire the side break (parking brake)
for safety and preventing accidents. (=> page 23)
Notes:
e Be sure to fully plug in the connector.
e When game devices are connected, the image may be unstable.
| em | ^