Replacing The Power Supply Assembly - Lenovo ThinkCentre M900z 10F2 Hardware Maintenance Manual

Replacing the power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the back cover. See "Removing the back cover" on page 90.
3. Remove the computer cover. See "Replacing the computer cover" on page 95.
4. Remove the system board shield. See "Replacing the system board shield" on page 98.
5. Remove the VESA mount bracket. See "Replacing the VESA mount bracket" on page 99.
6. Locate the power supply assembly. See "Major FRUs and CRUs" on page 31.
7. Disconnect the power supply assembly cable from the system board.
.
Chapter 9 Installing or replacing hardware
101