Replacing The Storage Drive - Lenovo ThinkCentre M900z 10F2 Hardware Maintenance Manual

5. Insert the notched end
and pivot the memory module until it snaps into position. Ensure that the memory module is secured
in the slot and does not move easily.
Figure 24. Installing a memory module
6. Install the memory module shield. See "Replacing the memory module shield" on page 91.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 116.

Replacing the storage drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the storage drive, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the back cover. See "Removing the back cover" on page 90.
3. Locate the storage drive. See "Computer components" on page 31.
4. Press the handle 1
to remove them from the chassis.
Figure 25. Removing the storage drive bracket and the storage drive
5. Disconnect the storage drive cable from the storage drive.
2 of the new memory module into the slot
as shown, and then pivot the storage drive bracket and the storage drive as shown
1 . Press the memory module firmly
.
Chapter 9 Installing or replacing hardware
93