In The Field Techniques - Titan 3000XD Owner's Manual

IN THE FIELD TECHNIQUES

RETUNING
TEMPERATURE CHANGE
PINPOINTING
How To Pinpoint Targets Using The
PINPOINT Mode
When you've discovered a target you wish to dig,
do the following:
1. Hold the searchcoil about half an inch above the ground,
off to the side of where you think the target probably is.
2. Tap the PINPOINT touchpad button. This will put you into the All Metal Pinpoint
mode. NOTE: unlike the other modes, this mode does not require the searchcoil to
be in motion to detect a target.
3. Lift the searchcoil slightly, and pass it over the target. The sound will be loudest over
the center of the target.
To Narrow It Down Further:
4.Now that you know about where the target is, again lower the searchcoil to about half
an inch above the ground, near the center of the target but not right over the top. Tap
the button again. The sound will instantly go away.
5.Lift the searchcoil slightly and move it horizontally
over the target. The audible response zone will be
much narrower. If you move the searchcoil around
right and left and also forward and back, making an
"X" pattern over the target, you can determine the
location of the target usually within an inch or two.
NOTE: if at any time it seems like the signal may be
drifting, just tap the Pinpoint button. This restores
the signal to its zero level.
(continued)
Pinpoint
Mode