Pinpoint; Headphone Jack - Titan 3000XD Owner's Manual

BASIC OPERATION
4) Press ITD. An "R" appears under the segment to be eliminated.
5) Pass the search coil over the same object again.
The undesirable object is eliminated from detection
The ITD control is easy to use in the field. As you are detecting, and encounter
an object which you wish to eliminate from detection, simply press the ITD
touch pad after detecting the object.
The ITD control eliminates the most-recently detected object category from
detection. The category eliminated is indicated with an "R".
PIN POINT MODE
Since long-buried objects can appear exactly like the surrounding soil, the
process of finding the exact location of a small object, such as a coin, can be
time-consuming and frustrating. Objects buried many inches deep present
an especially daunting challenge. In addition, during the unearthing process,
care must be taken not to damage valuable relics. The best solution to these
problems is the no-motion PINPOINT mode.
At any time during operation, press the PINPOINT touch pad, and the detector
enters the no-motion mode. In the PINPOINT mode, any object in the coil's
detection field will induce a monotone hum. The location of a coin-sized object
can be discerned with pinpoint accuracy by narrowing the detection field as
described on page 21.
Be sure that the detector is properly GROUND BALANCED before using the
PINPOINT MODE. See page 19 for manual ground balancing instructions. Also,
consult page 21 for proper no-motion field techniques.
The Target Identification and Target Depth
indicators are disabled in this mode. To
discern the identification and depth of an
object, you must use one of the motion
modes of operation.

HEADPHONE JACK

Using headphones (not supplied) with your
metal detector makes it easier to identify
subtle changes in the threshold levels for
better detection results, and also reduces
drain on the batteries. The Titan 3000 XD
Metal Detector has a stereo headphone
jack located at the rear of the case.
This device is to be used with interconnecting
cables/headphone cables shorter than three meters.
(continued)