Ipv6 Static Routing - Cisco ASR 5000 series Product Overview

Hide thumbs Also See for ASR 5000 series:

Table of Contents

▀ Features and Functionality - Base Software

IPv6 Static Routing

Native IPv6 routing allows the forwarding of IPv6 packets between IPv6 networks. The forwarding lookup is based on

destination IPv6 address longest prefix match.

PDIF supports configuration of static routes including a default route. If a default route is configured, all IPv6 traffic is

forwarded to the configured next-hop defined by the default route.

Port-Switch-On-L3-Fail for IPv6

IPv4 port failover redundancy if L3 connectivity is lost is extended to support IPv6 addresses.

For more information on configuring port-switch-on-l3-fail, see Ethernet Interface Configuration Commands in the

Command Line Interface Reference and Creating and Configuring Ethernet Interfaces and Ports in the System Element

Configuration Procedures section of the System Administration Guide.

IKEv2 Keep-Alive (Dead Peer Detection (DPD))

PDIF supports DPD protocol messages originating from both the MS and the PDIF/FA. DPD is configured on a per-

PDIF-service basis. The administrator can also disable DPD and the PDIF/FA does not initiate DPD exchanges with the

MS when disabled. However, the PDIF/FA always responds to DPD availability checks initiated by the MS regardless

of the PDIF/FA idle timer configuration.

Congestion Control and Overload Disconnect

Congestion control is an operator-configurable facility. When the PDIF chassis reaches certain limits (based on CPU

utilization, port utilization, and other controls) the system enters a congested state. When in a congested state, existing

calls are not impacted but new calls are potentially restricted.There is a separate subscriber-level configuration to

enable/disable the feature on a per-subscriber basis. There is also a subscriber-level configurable for

The disconnection scenario is as follows:

disconnection.

disconnection.

time greater than the idle-time threshold and a connect-time greater than the connect-time-threshold would be

selected for disconnection.

▄ Cisco ASR 5000 Series Product Overview

For a number of failure scenarios involving Dead Peer Detection, refer to the Troubleshooting

thresholds to remove some old and abandoned calls from the system.

is configured, sessions exceeding this threshold would be selected for

is configured, sessions exceeding this threshold would be selected for

Packet Data Interworking Function Overview

are configured, sessions with an idle-