Operating Instructions; Engine Oil Recommendations - Dirty hand 107036 Operation Manual

Operating Instructions

!
DANGER
WARNING: Read and understand the complete Operation
Manual before assembling or using this product! Failure
to comprehend and comply with warnings, cautions and
instructions for assembly and operation could result in serious
injury or death.
Do not permit children to operate this equipment at any time.
Do not permit others that have not read and understood
the complete Operation Manual to operate this equipment.
Operation of power equipment can be dangerous. It is the sole
responsibility of the operator to understand the assembly and safe
operation of this product.
Call our customer service department at 720-287-5182,
1-877-487-8275, or visit www.dirtyhandtools.com if you have
any questions or concerns about the safe operation of this
equipment.
!
CAUTION
The hydraulic reservoir should be filled with hydraulic fluid
and the engine should be filled with engine oil
before starting or operation.
STEP 1: Add approximately 4 gallons of hydraulic fluid. The
remaining hydraulic fluid will be added after the cylinder
is cycled. AW32 or AW46 hydraulic oil is recommended.
Automatic transmission fluid can be substituted instead of
hydraulic oil when temperatures are below 32°F. Use only clean
oil and take care to prevent dirt from entering the hydraulic
reservoir.

ENGINE OIL RECOMMENDATIONS

Use 4-stroke automotive detergent oil. SAE 10W-30 is
recommended for general use. Refer to the SAE Viscosity
Grades chart in your engine owner's manual for average
temperature ranges. The engine manufacturer recommends using
API SERVICE Category SE or SF oil. The engine oil capacity is
20 oz. for Kohler SH265 (22-Ton/27-Ton) and 40 oz. for Kohler
CH395 (35-Ton). Always check oil level before starting the
engine and keep level full.
13