Mechanical Installation - Electrolux W555H Installation Manual

10

3.3 Mechanical installation

If the machine is not to be mounted on a base the machine must be fastened to the floor.
Mark and drill two holes (⌀ 8 mm) about 40 mm deep.
A
mm
530
Place the machine over the two drilled holes. The holes are at the front of the machine.
Level the machine with the feet of the machine. Screw in the feet as much as possible before starting to level the ma-
chine. This will make the machine stand steadier.
Insert the expansion bolts supplied into the holes drilled in the floor. Fit the washers and nuts and tighten well.
It is of the upmost importance that the machine is placed in level, from side to side as well as front to rear. If the
machine is not properly levelled, it may result in out-of-balance without a real out of balance in the drum.
Installation manual
B C
490 35
D E
125 290
F G
150 40
fig.5358
H
50