Frequently Asked Questions - Philips Faro M770 Short User Manual

Frequently asked questions

My handset displays [Searching] or
[Unavailable], or [Register your Handset],
what do I do?
• Make sure that the base station has power
supply.
• The handset is out of range. Move it closer to the
base station.
• The handset is not paired with the base. Register
the handset to the base station.
If I fail to pair (register) the additional
handsets to the base station, what do I do?
• Your base memory is full. Access >
[Services] > [Unregister] to unregister the
unused handsets and try again.
• If registration fails, unplug the power adapter
from the base station and plug it back. Wait for
15 seconds, and then repeat the registration
procedure.
I have chosen a wrong country in Welcome
screen, what do I do?
Reset your phone settings to the original factory
settings (see the section on "Restore default
settings").
I have chosen a wrong language which I
cannot read, what do I do?
1 Press to go back to the standby screen.
2 Press
to access the main menu screen.
3 The following options will appear on the screen:
[Phone setup] > [Language]
[ 電話設定 ] > [ 語言 ]
4 Select them to access the language options.
5 Select your own language.
The handset loses connection with the
base or the sound interrupts during a call.
• The handset is nearly out of range. Move it closer
to the base station.
• Check if the ECO mode is activated. Turn it off
to increase the handset range and enjoy the
optimal call conditions.
• Re-register the handset to the base station.
The handset on the charger does not
charge or the battery discharges too fast.
• Make sure the batteries are inserted correctly.
• Make sure the handset is placed properly on the
charger. If the docking tone is turned on, you
can hear the docking tone when you place the
handset on the charging cradle. The battery icon
animates when charging.
• The charging contacts are dirty. Disconnect the
power supply first and clean the contacts with a
damp cloth.
• The battery is not fully recharged. Leave the
handset on the charging cradle for at least
8 hours or until the battery icon on the handset
stops scrolling and indicates full bar.
• The batteries are old or defective. Purchase and
replace with new rechargeable batteries with the
same specifications.
Bad audio (crackles, echo, etc.)
• The handset is nearly out of range. Move it closer
to the base station.
• The phone receives interference from the nearby
electrical appliances. Move the base station
away from them.
• The phone is at a location with thick walls. Move
the base away from them.
• The phone receives interference from the DSL
(digital subscriber line) connection. Install a DSL
filter to prevent the noise. Contact your service
provider for the DSL filter.
The caller ID does not display.
• The service is not activated. Check with your
service provider.
• The caller's information is withheld or
unavailable.