Table of Contents
Advertisement
Message
Current Interface Speed: xxxMbps
Duplicate IP = <IP address> (from <MAC
address>).
IEEE 802.11 Card does NOT support WPA .
IEEE 802.11 Card Firmware REV.<version>
IEEE 802.11 card removed
IEEE 802.11 current channel <channel nember>
IEEE 802.11 interface down
IEEE 802.11 interface up
IEEE 802.11 MAC Address = <MAC address>
IEEE 802.11 SSID <ssid> (AP MAC Address
<MAC address>)
IEEE 802.11 <communication mode> mode
inetd start.
Interface (interface name): Duplicate IP Address
(<IP address>).
< Interface > started with IP: < IP address >
Problem and solutions
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
The same IP address (IPv4, or IPv6 address) was
used. Each IP address (IPv4, or IPv6 address) must
be unique. Check the address of the device
indicated in [MAC address].
A wireless card that does not support WPA is
installed. Install a wireless card that supports WPA.
Displays the version number of the 802.11 card's
firmware.
The wireless card managed by the supplicant has
been removed.
Displays the current channel number of the active
wireless card (in ad hoc and infrastructure mode).
The IEEE 802.11 interface managed by the
supplicant is disabled, or cannot connect to the
access point.
The IEEE 802.11 interface managed by the
supplicant is enabled, or is connected to the access
point.
Displays the MAC address of the wireless interface.
The MAC address and SSID of the access point are
connected in infrastructure mode.
Displays IEEE 802.11 communication mode.
The inetd service has started.
The same IP (IPv4 or IPv6) address was used. Each
IP address must be unique. Check the address of
the device indicated in [IP address].
IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
Message List
2
125
Advertisement
Table of Contents
